Wipe away any mod podge that comes out the edges.
Ceramic tile coasters mod podge.
Let dry then put another layer or two of mod podge on top.
Spray the tops of the tiles with engine enamel or seal with minwax polycrylic.
Let dry at least 15 20 minutes.
Repeat with the other tiles and photos.
Cut felt and glue on bottom of tile.
Don t lift it up once you get it on or it will rip and become a big ol mess.
Once the coasters are sprayed with the sealer they will no longer be tacky.
Paint a thin coat of mod podge onto a tile.
Lay the photo onto the tile centering it and smoothing out all of the air bubbles.
Apply a light coat of mod podge to each tile with a sponge brush then center your paper on top.
After they dry here is what they look like.
Apply a layer of mod podge to the tile and then place the felt in the center.
Use mod podge to adhere the scrapbook paper or fabric to the top of your tile.
That s where the clear acrylic sealer comes in.
Work on one tile at a time use your fingers to press the paper nice and flat.
This is the back of the coaster and will allow you to move the tiles around without having to worry about scratching any tabletops.
Repeat for all of your tiles.
Allow tile to dry fully before you handle.
To make these coasters you get some 4 1 4 square ceramic tiles from a home improvement store like home depot and decoupage scrapbook paper to them using a product called mod podge.
The ceramic tiles are super duper affordable usually sold for about 10 cents apiece and if you have lots of odds and ends of scrapbook paper you might have to fight the urge to make like 50 coasters.